Note that the reflector isn't positioned hanging down below the boom arm, it is parallel to the boom arm to the sideĢ) The reflector hanging out puts a lot of potential for tipping the stand. The clamps just aren't strong enough to handle the moment arm of the reflector. The extender arm should be aligned with one of the light stand legs (and spread the legs as much as possible).ġ) The clamps on the shaft offer minimal resistance to rotating and changing the angle of the reflector. If you need down, use the extender arm perpendicular to the light stand and attach the reflector boom arm to it. Or get a reflector boom arm that has a mount between the reflector clamps this balances better than the cantilever style but won't reflect down. If you need to aim it down, get an extender arm that can mount perpendicular to the light stand, put the reflector clamp on the end and use a regular clamp to hold the bottom. Some of these won't open enough for the 5-in-1 models but there's usually a gap in the cover where you can clamp. Get a reflector clamp that mounts on a light stand, use an umbrella mount if you need to adjust it. Get a clamp that mounts on an umbrella mount and you can hold the reflector up with a light stand. Are there mounts that hold the reflector in front of the stand? However, it is entirely cantilevered requiring a larger stand or weights on the stand. I have a Photoflex arm to hold the large reflector. What is the best way to support small reflectors? There are there is no one to accurately hold the reflector. Reflectors are common and I have several 5-in-1 models: a 60" round, a 32" round with two molded handles, and a 32" triangle with one molded handle.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |